Gauges
A fuel gauge (or gas gauge) is an instrument used to indicate the level of fuel contained in a tank. Commonly used in cars, these may also be used for any tank including underground storage tanks. more...
 Home
ATV Parts
Apparel & Merchandise
Automotive Tools
Aviation Parts
Boats Parts
Car & Truck Parts
Car Audio, Video
Manuals & Literature
Motorcycle Parts
Other
Other Vehicle Parts
Personal Watercraft Parts
Racing Parts
 Accessories
Auto Racing Parts
 Body & Exterior
Chassis, Suspension & Brakes
Driveline & Transmission
 Other
Rear End
Transmission
Electrical
Chips, Programmers
Ignition
Other
Wiring Kits
Engine & Components
Exhaust
Fuel Systems
Fuel Injection & Pumps
Fuel Pressure Regulators
Hoses, Lines & Fittings
Other
Induction
Carburetors
Cold Air Intake
Forced Induction
Intake Manifolds
Nitrous Oxide
Other
Interior
Gauges
Other
Seats
Other
Wheels & Tires
Fasteners, Fluids & Gaskets
Kart Racing Parts
Other
Safety Equipment
Services & Installation
Snowmobile Parts
Vintage Car & Truck Parts
Wholesale Lots
As used in cars, the gauge consists of two parts:
The sender unit;
The indicator;
The sending unit usually uses a float connected to a variable resistor. When the tank is full, the resistor is set to its low resistance value. As the tank empties, the float drops and the slides a moving contact along the resistor, increasing its resistance, finally reaching its highest value when the tank is empty. In addition, when the resistance is at a certain point, it will also turn on a "low fuel" light on some vehicles.
Meanwhile, the indicator unit (usually mounted on the instrument panel) is measuring and displaying the amount of electrical current flowing through the sending unit. When the tank level is high and maximum current is flowing, the needle points to "F" indicating a full tank. When the tank is empty and the least current is flowing, the needle points to "E" indicating an empty tank.
The system is fail safe; a fault that opens the electrical circuit causes the indicator to show the tank as being empty (which will provoke the driver to refill the tank) rather than full (which would allow the driver to run out of fuel with no prior notification).
Systems that measure large fuel tanks (including underground storage tanks) may use the same electro-mechanical principle or may make use of a pressure sensor, sometimes connected to a mercury manometer.
Large airplanes use a different fuel gauge design principle. An airplane has a few (around 30 on an A320) low voltage capacitors where the fuel can go between them. At different fuel levels there are different capacitances (i.e. capacitance proportional to the height of fuel) and therefore the level of fuel can be determined. For the aircraft pitch and roll attitudes the fuel computer works out how much fuel there is (slightly different on different manufacturers). In total this is more than 99% accurate.
A handy tip for car drivers that have ever forgotten which side to fill up on. The Fuel gauge in over 90% of cars have an arrow of some sort on it that points to the side that has the gas receptacle. Cars even use the little gas pump icon, which ever side the gas pumps hose and handle is on, is the side you refill on.
Read more at Wikipedia.org
|
